2gig Technologies EDGE Installation Manual page 15

5 . Tap Panel Programming to view programming options (see below).
P P – W Z
anel rogramming ireless ones
You can program up to 100 wireless zones per system. To get started, tap Wireless Zones to view the Wireless Zones screen.
Selecting a Wireless Zone
1 . On the left side of the Wireless Zones screen, swipe up or down to scroll
the list of zones.
2 . Tap and highlight one of the available zones.
3 . Tap EDIT ZONE to view settings for the selected zone.
Equipment Code
1 . Tap Equipment Code.
2 . Tap ≡
to expand the list.
3 . Tap to select the desired equipment code from the list.
4 . Tap t to move to the next option.
Sensor Type
1 . Tap Sensor Type.
≡
2 . Tap
to expand the list.
3 . Tap to select the appropriate sensor type from the list.
NOTE: You can also use the keypad to enter the two-digit
code to display a Sensor Type.
4 . Tap t to move to the next option.
Sensor Equipment Type (if needed)
If you selected 04-Interior Follower , 06-24-Hour Silent Alarm , 07- 24-Hour Audible Alarm
Type in "Sensor Type" above, you must also select this option ( continued next page
2GIG EDGE Installation Guide
, 24-Hour Auxiliary Alarm , 10-Interior with Delay , 23-No Response
).
28
If you selected a Sensor Type other than those listed above, skip this step.
1 . Highlight Sensor Equipment Type.
2 . Choose Contact, Emergency or Motion. Available options vary, depending on the selected Sensor Type.
3 . Tap t to move to the next option.
Enter TXID
1 . Tap TXID.
2 . Tap Learn to enter Learning Mode. This panel listens for the 7-digit TX
ID transmission from the sensor or peripheral.
TIP: Along with Learning Mode, you also have the option to
manually enter the 7-digit TX ID using the keypad.
3 . Trigger the sensor or peripheral (see the product's Installation
Instructions). When the 7-digit TX ID is received, Sensor Received
appears.
4 . Verify that the 7-digit TX ID on product and touchscreen match, then tap
Accept.
5 . Tap t to move to the next option.
Sensor Loop
1 . Highlight Sensor Loop.
2 . Choose Loop 1, Loop 2, or Loop 3.
NOTE: To determine the appropriate loop number, see the
Installation Instructions included with the sensor or peripheral.
3 . Tap t to move to the next option.
Voice Descriptor
Create a voice descriptor for the sensor or peripheral.
1 . Highlight Voice Descriptor.
2 . Tap Edit Voice Descriptor to reveal the keypad.
3 . Enter the first few letters of the desired word.
4 . Tap the matching word.
5 . Repeat the steps above to enter the desired phrase.
6 . Tap Done.
7 . Review the voice descriptor.
8 . Tap t to move to the next option.
Sensor Chime
1 . Highlight Sensor Chime.
2 . Choose the desired chime from the list. The default setting is Disabled.
Smart Areas Assignment
1 . Highlight Smart Areas Assignment.
2 . Under Smart Areas Assignment, choose a Smart Area (Partition) for the
zone.
3 . Tap t to move to the next option.
Transmission Delay
1 . Highlight Transmission Delay.
2 . Select Enabled or Disabled.
3 . Tap t to move to the next option.
Copyright © 2021 Nortek Security & Control LLC
29