Connect The Antenna - 2gig Technologies EDGE Installation Manual

Install Jumper
1 . Carefully disconnect the existing wire from the terminal location where one side of the Jumper will be connected.
Terminal
Exising Wire Disconnected
2 . Connect the Jumper Wire from the vacated terminal to the vacant Jumper terminal adjacent to the Antenna Terminal. The jumper wire
should snap into place on each terminal.
Jumper
Terminal
Jumper Wire
3 . Insert the exposed wire from Step 1 into the available foam holder to isolate it from exposure to other board components.
Insert
Wire
2GIG EDGE Installation Guide
Antenna
Terminal
Jumper Terminal
14

Connect the Antenna

.
1 . Connect the antenna terminal to the board terminal. You should feel it snap into place.
2 . Insert the antenna wire into the plastic clip.
3 . Secure the back plate to the panel.
Antenna
Wire Clip
Antenna Terminal
Copyright © 2021 Nortek Security & Control LLC
15