2gig Technologies EDGE Installation Manual page 18

Emergency Key
1 . Highlight Emergency Key.
2 . Choose one of these options:
➣ Disabled: Turns the emergency key function OFF.
➣ Auxiliary: Triggers an auxiliary alarm.
➣ Audible: Triggers an audible alarm on the system.
➣ Silent Panic: Triggers a silent distress signal.
3 . Tap t to move to the next option.
Fob Can Disarm
1 . Highlight Fob Can Disarm.
2 . Under Fob Can Disarm, choose Enabled or Disabled.
3 . Tap t to move to the next option.
Arm with No Entry Delay
1 . Highlight Arm with No Entry Delay.
2 . Choose Enabled or Disabled.
3 . Tap t to move to the next option.
Fob Output
1 . Highlight Fob Output.
2 . Choose one of these options:
➣ Disabled: This deactivates the option.
➣ Toggle Output: Press the Auxiliary (*) button to control
the device connected to the Open Collector Output #1. For
example: open and close a garage door.
➣ Momentary Output: Press the Auxiliary (*) button to change
the state of the device connected to the Open Collector
Output #1. For example: turn the system-controlled lights ON
or OFF.
P P – K
anel rogramming eyPads
You can program up to eight (8) wireless keypads per system. To get started, navigate to the Installer Toolbox. Then, tap Keypads. This reveals
the Keypads screen.
NOTE: 2GIG Edge panel and Remote Keypads must be connected
the same WiFi network, or the Remote Keypads must be
connected to the 2GIG Edge panels access point before starting
keypad programming. See Network Settings, page 38.
Keypad (#)
3 . Swipe up to move through the list of keypads.
4 . Tap to select one of the available keypads, then tap Edit Keypad.
5 . Make sure the Keypad Used setting is highlighted.
6 . Under Keypad Used, choose Enabled or Disabled.
7 . Tap t to move to the next option.
2GIG EDGE Installation Guide
34
Equipment Code
1 . Make sure Equipment Code is highlighted.
≡
2 . Tap to expand the list.
3 . Tap to select the desired equipment code from the list.
4 . Tap t to move to the next option.
5 . Tap PAIR KEYPAD. The panel will listen for a Keypad to pair.
6 . The panel will display the Keypad as "Connected".
7 . Tap t to move to the next option.
Smart Areas Assignment
1 . Highlight Smart Areas Assignment.
2 . Choose a Smart Area (Partition) for the Keypad.
3 . Tap t to move to the next option.
Edit Voice Descriptor
1 . Highlight the Voice Descriptor setting.
2 . Tap ADD VOICE DESCRIPTOR to reveal the touchscreen keypad.
3 . Enter the first few letters of the desired vocabulary word.
4 . Tap the matching vocabulary word above the touchscreen keypad to select it.
5 . Repeat the steps above to enter the desired phrase for the keypad.
6 . Tap Done.
7 . Review the voice descriptor.
Reset Keypad/Next Keypad
➣ Tap Reset Zone to erase all the programmed settings for the zone.
➣ Tap NEXT KEYPAD to program another Remote Keypad.
Copyright © 2021 Nortek Security & Control LLC
35