Sensor Supervised; Advanced Programming Reference - 2gig Technologies EDGE Installation Manual

Sensor Reports
Required for all wireless and wired zones.
Sensor Reports Choosing this setting ...
Enabled (Default) Sends reports to the Central Station.
Disabled Does NOT send reports to the Central Station.

Sensor Supervised

Required for all wireless zones.
Sensor Supervised Choosing this setting ...
Enabled (Default) Enables the sensor supervision feature.
Disabled Disables the sensor supervision feature.
Sensor Chime
Required for all wireless and wired zones.
Sensor Chime Setting
Disabled (Default)
Voice Only
Ding-Dong #1 with Voice
Ding-Dong #2
Ding-Dong #2 with Voice
Ding-Dong #1
Ding-Ding
Ding-Ding with Voice
Ding-Dong #3
Ding-Dong #3 with Voice
Chime #1
Chime #1 with Voice
Chime #2
Chime #2 with Voice
2GIG EDGE Installation Guide
60

Advanced Programming Reference

This table summarizes the system's panel programming questions, the available settings for each question, and each question's factory-default
setting.
Question
Question Text Available Settings
Number
Q101 Enter installer code (4 or 6 digits) Unique 4-Digit Number
Q102 Security pin code length 4 or 6 digits
Disabled (Full Access)
Q103 Lock installer programming No Access
Limited Access
Allow Reset of All Defaults
Q104
Lock default programming Allow Limited Reset of Defaults
Do Not Allow Reset of Defaults
Disabled
Stay online
Q105
2-way voice
Stay online, including fire and CO
alarms
Yes
Q106 Disable siren after two-way audio
No
Enabled
Q107 Smart Areas
Disabled
Disabled and Hidden
Disabled but Visible
Q108
Z-Wave feature
Enabled
Enabled with Local Scenes Hidden
Master user can access Z-Wave Enabled
Q109
setup Disabled
Smart Home Controls require Enabled
Q110
master code Disabled
All Smart Areas
Q111 Main Panel Sounder Follows
Main Panel Smart Area Only
Sound for Burglary and Fire/CO Sound
Q112
Z-Wave siren mode
for Burglary Only
Enabled
Q113 Quick arming
Disabled
Enabled
Q114 Auto stay
Disabled
Enabled
Q115 Exit delay restart
Disabled
Enabled
Q116 Allow quick exit
Disabled
Enabled
Q117
Quick bypass
Disabled
Enabled
Q118 Auto unbypass for manual bypass
Disabled
Programming
Factory Default Setting Page Reference
Category
1561 System Configuration 43
4 System Configuration 43
Disabled (Full Access) System Configuration 43
Allow Reset of All Defaults System Configuration 43
Stay online System Configuration 43
No System Configuration 44
Disabled System Configuration 44
Enabled System Configuration 44
Disabled System Configuration 44
Disabled System Configuration 44
All Smart Areas System Configuration 44
Sound for Burglary and Fire/
System Configuration 45
CO
Enabled System Configuration 45
‡Enabled System Configuration 45
‡Enabled System Configuration 45
Enabled System Configuration 45
Disabled System Configuration 46
Enabled System Configuration 46
Copyright © 2021 Nortek Security & Control LLC
61