2gig Technologies EDGE Installation Manual page 21

Access Point
Setup the 2GIG EDGE Panel Access Point.
1 . Tap Network Settings.
2 . Tap Access Point.
3 . Enable Access Point:
➣ Optional: Tap (
) to enter a new SSID name
➣ Optional: Tap ( ) to enter a new password
➣ Optional: Tap ( ) IP address. The last two octets of the Access Point can be
changed to customize the setup.
4 . If edits have been made, tap SAVE SETTINGS to save.
NOTE: Make a note of SSID and Password for use in WiFi setup of 2GIG EDGE
Remote Keypads, approved video doorbells and cameras.
5 . Tap  to go back to the Network Settings menu.
s H s
mart ome ettings
You can add up to 232 Z-Wave devices to the network. After adding or removing a
device you should always rediscover the network. Tap Settings, then Smart Home
Settings to view the Smart Home Settings menu.
Refer to the 2GIG EDGE Smart Home Manual for complete use and setup information.
View All Devices
Displays all Z-Wave Smart Home Devices connected to the panel.
Add Device
1 . Tap Add Devices. The Listening for Devices to Add page appears.
2 . Walk to and trigger the device on the network. When the system discovers a device, the
system automatically adds it and the Adding Device message appears.
3 . Tap OK. The newly discovered device appears. Any device information captured during the
discovery process appears below the device name.
Remove Device
At the Smart Home Settings menu, tap Remove Device. Follow on-screen instructions to remove specific devices.
Check Network
1 . Tap Check Network to check the network for failed nodes.
2 . Tap TEST. The system scans the network for failed nodes. This can take several minutes and some of the Z-Wave functions will be unavailable until the
rediscovery is complete.
Rediscover Network
1 . Tap Smart Home Settings .
2 . Tap TEST.
3 . Tap START. The Working screen appears.
2GIG EDGE Installation Guide
40
s t
ystem est
NOTE: The Panel Test and Network Test were not evaluated to ANSI SIA CP-01:
2010, Initiation of Test and Termination Test
Sensor Tests
After installing the system, sensors, and peripherals, perform a walk test to ensure
proper console operations and to test wireless reception and signal strength.
➣ Tap Sensors Tests, then walk to and trigger each sensor.
Panel Testing
Tap each button and respond Yes or No to each question. If any of the tests fail,
please contact your dealer for assistance.
Disable Sounder
Press YES to disable the Sounder. The panel will beep. The siren will be silent for 30
minutes or until it is re-enabled manually.
Cell Radio Test/Status
At the Radio Status screen, tap Test Cell Radio. Status for Signal Strength
Number , Subscriber ID , Registration Status , Connection Status and Power Status
displayed.
Network Test
Tap this option to test LAN, Internet and Backend network connection status.
NOTE: The system is to be tested upon completion of the installation.
, Serial
will be
Copyright © 2021 Nortek Security & Control LLC
41