Terminal Blocks Wiring Diagram - 2gig Technologies EDGE Installation Manual

Replacing the Battery (continued)
4 . Insert the new battery, and attach the power cable
5 . Replace the back cover.
2GIG EDGE Installation Guide
Connect
Power
22

Terminal Blocks Wiring Diagram

The 2GIG EDGE Panel includes an 8-position terminal block and a 6-position terminal block. The table below describes each position on the
terminal blocks.
NOTE: Terminal block accommodates up to 18 gauge wire.
Terminal Block Positions*
1
GND DC IN
2
AUX+ DC IN + 9
3 10
GND DC IN –
4 11
Bell + OCL 1
5 12
Bell – OCL 2
6 Zone 1 TX 13
7 14
Zone 2 RX
8
GND
Position Label Description
1 GND (DC OUT–) GND (DC OUT–)
2 AUX+ 5VDC @500mA Max
3 GND Ground (Low Side Hardwire Zone)
4 Bell + 5-14VDC @ 200mA Max
NOTE: Bell Output is only active when Edge Panel is powered by the
5 Bell –
AC power source.
6 ZONE 1 Hardwire Loop Zone 1
7 ZONE 2 Hardwire Loop Zone 2
8 GND Ground (Low Side Hardwire Zone)
14 VDC Power Input (+). Only provides power when the 2GIG EDGE
9* DC OUT +
Panel's power supply is connected to an AC power source.
10* DC OUT – 14 VDC Power Input (–)
11 OCL 1 Open Collector Output 1
12 OCL 2 Open Collector Output 2
13 TX Image Sensor TX
14 RX Image Sensor RX
Copyright © 2021 Nortek Security & Control LLC
23