2gig Technologies EDGE Installation Manual page 17

Glass Break
To program the built-in Glass Break sensor, adjust the following
settings.
Sensor
1 . Tap Glass Break.
2 . Choose Enabled or Disabled.
3 . Tap t to move to the next option.
Voice Descriptor
1 . Highlight Voice Descriptor.
2 . Tap Edit Voice Descriptor to reveal the keypad.
3 . Use the keypad to enter the first few letters of the desired word.
4 . Tap the matching word above the keypad.
5 . Repeat the steps above to enter a phrase.
6 . Tap Done.
7 . Review the voice descriptor.
8 . Tap t to move to the next option.
Transmission Delay
1 . Highlight Transmission Delay.
2 . Choose Enabled or Disabled.
3 . Tap t to move to the next option.
Sensor Reports
1 . Highlight Sensor Reports.
2 . Choose Enabled or Disabled.
3 . Tap t to move to the next option.
2GIG EDGE Installation Guide
32
P P – K
anel rogramming eyfoBs
Program up to 32 keyfobs per system. To begin, navigate to the Installer Toolbox, then tap Panel Programming > Keyfobs.
Select a Keyfob
1 . Swipe up to move through the list of keyfobs.
2 . Tap to select one of the available keyfobs.
3 . Tap Edit Keyfob.
1 . Highlight Fob Active.
2 . Under Fob Used, choose Enabled or Disabled.
3 . Tap t to move to the next option.
Select Equipment Code
1 . Highlight Equipment Code.
≡
2 . Tap to expand the list.
3 . Tap to select the desired equipment code from the list.
4 . Tap t to move to the next option.
Serial Number
1 . Highlight Serial Number.
2 . Tap Learn to enter Learning Mode.
3 . The 7-digit TX-ID listed on the product is detected.
4 . Press any button on the keyfob for three 3 – 5 seconds. The Sensor
Received message appears if successful.
TIP: Along with Learning Mode, you also have the option to
manually enter the 7-digit TX ID using the keypad.
5 . Verify the on-screen serial number matches the keyfob's 7-digit TX ID,
then tap Accept.
6 . Tap t to move to the next option.
Edit Voice Descriptor
Create a voice descriptor for the keyfob using the words in the
system's vocabulary.
1 . Highlight Voice Descriptor.
2 . Tap Edit Voice Descriptor to view the keypad.
3 . Enter the first few letters of the desired word.
4 . Tap the matching vocabulary word above the touchscreen keypad to
select it.
5 . Repeat the steps to enter phrases, then tap Done.
6 . Review the voice descriptor.
7 . Tap t to move to the next option.
Smart Areas Assignment
1 . Highlight Smart Areas Assignment.
2 . Under Smart Areas Assignment, choose a Smart Area (Partition) for the
keyfob.
3 . Tap t to move to the next option.
Copyright © 2021 Nortek Security & Control LLC
33