Attach The Gth Quad Connector - Xilinx Virtex-7 FPGA VC7215 Getting Started Manual

Chapter 1: VC7215 IBERT Getting Started Guide

Attach the GTH Quad Connector

Before connecting the BullsEye cable assembly to the board, firmly secure the blue
elastomer seal provided with the cable assembly to the bottom of the connector housing if
it is not already inserted (see
Note:
X-Ref Target - Figure 1-4
Attach the Samtec BullsEye connector to GTH Quad 115
indexing pins on the bottom of the connector with the guide holes on the board. Hold the
connector flush with the board and fasten it by tightening the two captive screws.
X-Ref Target - Figure 1-5
10
Send Feedback
Figure
Figure 1-4 is for reference only and might not reflect the current version of the connector.
Figure 1-4: BullsEye Connector with Elastomer Seal
Figure 1-5: BullsEye Connector Attached to Quad 115
www.xilinx.com
1-4).
(Figure
VC7215 Getting Started Guide
UG970 (v7.0) November 24, 2014
1-5), aligning the two