Xilinx Virtex-7 FPGA VC7215 Getting Started Manual page 9

All GTH transceiver pins and reference clock pins are routed from the FPGA to a connector
pad which interfaces with Samtec BullsEye connectors.
pad.
X-Ref Target - Figure 1-2
The SuperClock-2 module provides LVDS clock outputs for the GTH transceiver reference
clocks in the IBERT demonstrations.
SMA connectors on the clock module which can be connected to the reference clock cables.
Note:
board.
X-Ref Target - Figure 1-3
The four SMA pairs labeled CLKOUT provide LVDS clock outputs from the Si5368 clock
multiplier/jitter attenuator device on the clock module. The SMA pair labeled Si570_CLK
provides LVDS clock output from the Si570 programmable oscillator on the clock module.
Note:
SuperClock-2 module.
For the GTH IBERT demonstration, the output clock frequencies are preset to 325.00 MHz.
For more information regarding the SuperClock-2 module, refer to HW-CLK-101-SCLK2
SuperClock-2 Module User Guide (UG770)
VC7215 Getting Started Guide
UG970 (v7.0) November 24, 2014
Figure 1-2 B shows the connector pinout.
Figure 1-2: A – GTH Connector Pad. B – GTH Connector Pinout
The image in Figure 1-3 is for reference only and might not reflect the current revision of the
Figure 1-3: SuperClock-2 Module Output Clock SMA Locations
The Si570 oscillator does not support LVDS output on the Rev B and earlier revisions of the
www.xilinx.com
Running the GTH IBERT Demonstration
Figure 1-2
Figure 1-3 shows the locations of the differential clock
[Ref 2].
A shows the connector
9
Send Feedback