Christie TruLife+ Griffyn 4K32-RGB Technical Reference page 7

• Japan: 81-3-3599-7481
• Singapore: +65 6877-8737
• South Korea: +82 2 702 1601
• Christie Professional Services: +1-800-550-3061 or NOC@christiedigital.com
Connection and use
Once you have connected your computer to either the RS232 IN port (depending on which standard is
supported by your computer) or to the Ethernet port on Christie TruLife+, you can remotely access
controls and image setups, issue commands or queries, and receive replies.
Use these bidirectional messages to:
• Control multiple projectors
• Obtain a projector's status report
• Diagnose performance problems
Refer to the User Manual provided with the projector for all cable requirements and other connection
details.
Some commands are operational only when projector is powered up.
Connecting to a computer or server with 10/100/1000 base-T
Ethernet
Communicate with a remote computer, server, or an existing network using a RJ-45 cable.
The port located on the Video Input panel uses Christie-proprietary protocol or Art-Net control protocol
and is intended for Christie accessories or automation controllers only.
1. Use an RJ-45 cable to connect the Ethernet hub or switch to the Ethernet port, located on the
projector Video Input panel.
2. When using the Christie serial protocol over Ethernet, connect to port 3002.
3. For applications or equipment using serial communications, use the Christie-proprietary serial
protocol or Art-Net protocol to communicate with the Ethernet port on the Video Input panel.
Configuring the RS232 port
Configure the RS232 port to send Christie serial commands using a standard RS232 serial cable.
1. Select Menu > Communications > Projector Communication.
Christie TruLife+ Technical Reference–Serial Commands
020-103316-01 Rev. 1 (09-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Communicating with Christie TruLife+
7