Christie TruLife+ Griffyn 4K32-RGB Technical Reference page 41

(LAS+MAXA 25)
Adjust the overall output of the lasers to 80%:
(LAS+POWR 800)
LCB–Lens Motor Calibration
Calibrates all of the lens motors.
This command is only enabled when the projector is on.
Commands
Command Description
LCB 1 Runs calibration on all lens motors.
LCB+HOME Moves all lens motors back to the center flag for each
axis and sets their respective positions to 0.
LCB+LOCK <0 | 1> Locks all lens motors preventing the lens from moving.
This overrides all other lens functions.
LCB+ZOMR <0 | 1> Programs the lens connector board lens (LCBL) to
indicate that the lens is motorized or non-motorized.
LCB+ZOOM 1 Calibrates the zoom motor.
Examples
Start calibration:
(LCB 1)
Move the lens back to the home position:
(LCB+HOME)
LHO–Lens Horizontal Position Adjustment
Sets the lens horizontal location to an absolute position.
This command is only available when the projector is on.
Commands
Command Description
LHO?m Returns the minimum and maximum range of the zoom axis
based on the last lens calibration performed. The returned
range is persistent across AC cycles. (Read-only)
Christie TruLife+ Technical Reference–Serial Commands
020-103316-01 Rev. 1 (09-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Serial API commands
Values
1
—
0 = Unlocks motors (Default)
1 = Locks motors
0 = Lens does not have a zoom
(Default)
1 = Lens has a zoom motor
1
Values
—
41