Christie TruLife+ Griffyn 4K32-RGB Technical Reference page 39

Examples
Get the current wired jack enabled state:
(KEN+WIRE?)
Disable the front IR sensor:
(KEN+FRNT 0)
Disable the rear IR sensor:
(KEN+REAR 1)
LAS–Light & Output Settings
Configures the laser drive levels and uses the projector's LiteLOC
Commands
Command Description
LAS+BLUP <value> Sets the drive level of the blue lasers. The
actual value sent to the laser rack is
reduced based on the Master Laser Power.
Expressed as percentage with one decimal
point.
LAS+CSRX? Returns the color sensor X reading. (Read-
only)
LAS+CSRY? Returns the color sensor Y reading. (Read-
only)
LAS+CSRZ? Returns the color sensor Z reading. (Read-
only)
LAS+EBLU <0 | 1> Enables or disables the blue lasers.
LAS+EGRN <0 | 1> Enables or disables the green lasers.
LAS+ERED <0 | 1> Enables or disables the red lasers.
LAS+GRNP <value> Sets the drive level of the green lasers. The
actual value sent to the laser rack is
reduced based on the Master Laser Power.
(Saved value)
Expressed as percentage with 1 decimal
point.
LAS+MAXA <value> Configures the projector to operate correctly
up to the specified maximum ambient
temperature in Celsius. (Saved value)
Christie TruLife+ Technical Reference–Serial Commands
020-103316-01 Rev. 1 (09-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Serial API commands
™ feature.
Values
0 to 1000, where 1000 = 100%
635 (Default)
—
—
—
0 = Disables the blue lasers
1 = Enables the blue lasers (Default)
0 = Disables the green lasers
1 = Enables the green lasers (Default)
0 = Disables the red lasers
1 = Enables the red lasers (Default)
0 to 1000, where 1000 = 100%
615 (Default)
0 to 50
35 (Default)
39