Christie TruLife+ Griffyn 4K32-RGB Technical Reference page 56

Command Description
TDD <value> Configures where the sync pulse occurs.
(Saved value)
Enabled when the selected signal is a 3D
signal, 3D mode is enabled, and 3D Sync
Out is set to Emitter.
Examples
Return the 3D emitter delay value on main video:
(TDD?)
Set 3D emitter delay to 20.00 milliseconds on main video:
(TDD 2000)
TDM–3D Mode
Controls when input signals are processed as 3D or not.
Only applies to: Mirage models
Commands
Command Description
TDM <mode> Controls when input signals are processed
as 3D or not. (Saved value)
Christie TruLife+ Technical Reference–Serial Commands
020-103316-01 Rev. 1 (09-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Serial API commands
Values
0 = Lines up the sync pulse with the
transition (Default)
Negative value = Configures the sync pulse
to be slightly before the transition
Positive value = Configures the sync pulse
to be slightly after the transition
Values
0 = Turns off 3D processing for direct input
signals. Has no effect when a Dual Input 3D
port configuration is selected. Useful for
displaying 2D 120Hz signal. It prevents a
Missing External 3D Synch
event from occurring.
SPC-2145
1 = Automatically determines whether to
enable 3D processing or not. When input
signals are 60Hz or less, no frame doubling
or tripling occurs unless a Dual Input 3D
channel is selected. (Default)
2 = Configures the projector to enable 3D
processing where possible. Frame doubling
occurs when input signals are 60Hz. Frame
tripling occurs when input signals are
48-50Hz.
3 = Side-by-Side 3D
5 = Top-and-Bottom 3D
6 = Frame Packing 3D
56