Christie TruLife+ Griffyn 4K32-RGB Technical Reference page 40

Command Description
LAS+MAXH <value> Sets the expected relative humidity in
percent of the environment where the
projector is operating. (Saved value)
This is only applicable if the projector is
running LiteLOC
LAS+MODE <value> Enables or disables LiteLOC.
LAS+POWR <value> Adjusts the overall output of the lasers while
maintaining the overall ratio of power
between each color. (Saved value)
Expressed as percentage with one decimal
point.
LAS+REDP <value> Sets the drive level of the red lasers. The
actual value sent to the laser rack is
reduced based on the Master Laser Power.
(Saved value)
Expressed as percentage with one decimal
point.
LAS+UDEC <value> Enables either automatic or manual setting
of LiteLOC user defined environmental
controls. (Saved value)
The manual selection allows user selection
of LAS+MAXA and LAS+MAXH values.
LAS+WHTX <value> Defines the white x color target value. The
value is expressed with four decimal points.
(Saved value)
LAS+WHTY <value> Defines the white y color target value. The
value is expressed with four decimal points.
(Saved value)
Examples
Enable LiteLOC:
(LAS+MODE 0)
Disable the green laser:
(LAS+EGRN 0)
Change the red laser drive level to 100%:
(LAS+REDP 1000)
Return the color sensor Z reading:
(LAS+CSRZ?)
Set the expected maximum ambient temperature to 25°C:
Christie TruLife+ Technical Reference–Serial Commands
020-103316-01 Rev. 1 (09-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
™
with User mode active.
Serial API commands
Values
0 to 100
80 (Default)
0 = LiteLOC 1 (deprecated)
1 = Disables LiteLOC
2 = LiteLOC 2 (deprecated)
3 = Enables LiteLOC
0 to 1000, where 1000 = 100%
750 (Default)
0 to 1000, where 1000 = 100%
820 (Default)
0 = Automatic—the software calculates the
maximum ambient and humidity conditions
(Default)
1 = Manual selection—allows for more user
tuning in LiteLOC
2500 to 4500, where 4500 = 0.4500
3127 (Default)
2500 to 4500, where 4500 = 0.4500
3290 (Default)
40