Christie TruLife+ Griffyn 4K32-RGB Technical Reference page 45

Command Description
Examples
Get current menu position preset:
(MSP?)
Set the on-screen display position to the top left corner of the screen:
(MSP 0)
NET–Network Setup
Modifies the network setup for this device.
By default, DHCP support is turned on.
Commands
Command
NET "<ip>" "<subnet>"
"<gateway>"
NET+DGRP "<group>"
NET+DHCP 1
NET+ETH0?
NET+GATE?
NET+HOST "<name>"
NET+MAC0?
Christie TruLife+ Technical Reference–Serial Commands
020-103316-01 Rev. 1 (09-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Description
Sets the projector network settings as specified. (Saved
value)
Sets the device group name for the projector. (Saved
value)
This can help simplify broadcast searching by
organizing projectors into groups, particularly if a large
number of projectors are on the same local network.
Enables DHCP. To turn off DHCP support, switch to a
static IP by using the base command. (Saved value)
Returns the projector IP address. (Read-only)
Returns the projector gateway address. (Read-only)
Sets the name for the projector. (Saved value)
With this set, devices on the same network subnet as
the projector can connect to it using the name:
<name>.local.
Returns the MAC address of the Ethernet port. (Read-
only)
Serial API commands
Values
2 = Top right
3 = Center left
4 = Center
5 = Center right
6 = Bottom left
7 = Bottom center
8 = Bottom right
Values
All three arguments are
strings and the gateway is
optional.
group = Group name for
the projector
1
—
—
name = Name for the
projector
—
45