Appendix C - Mounting Your Devices; Mounting Guidelines; Mounting Your Extio 3 Device - Matrox Extio 3 Series User Manual

Appendix C – Mounting your devices
This section provides guidelines for mounting your Extio N3408 or N3208 device.

Mounting guidelines

To prevent damage to your Matrox hardware, read the following guidelines before mounting your
Matrox hardware:
 Make sure not to block the ventilation holes on your device.
 Don't stack anything directly over the device.
 Make sure all cables and cords are slack.
 Make sure the ambient temperature doesn't exceed the maximum recommended
temperatures.

Mounting your Extio 3 device

You can mount two (2) devices horizontally on a single shelf.
Mounting shelf – Underside
Mounting shelf – Front
 To mount your device, use the holes labeled
from the front edge of the mounting shelf.
 Your device has two (2) mounting holes under its casing. Use two (2) 6 mm M3 flat-head
screws (included in the kit) to secure each device. You need to remove the four (4) rubber
pads under your device before you can secure your device to the shelf.
. These holes are 3.15 inches (8.00 cm)
M/E
Matrox Extio 3 Series – User Guide 95