Private Wan Setup; Private Wan Setup Requirements - Matrox Extio 3 Series User Manual

Private WAN setup

This section provides guidelines to set up Extio 3 IP KVM extenders to work over private
wide-area-networks (WAN).

Private WAN setup requirements

The following are required to set up Extio 3 IP KVM extenders over a private WAN:
 Firmware version - Extio 3 firmware version 3.01.50 or higher.
 Bandwidth - You need to ensure that the required network bandwidth is available for
your setup. Bandwidth requirement is tied to the video resolution, number of video
streams, and the application running on the source system. For more information,
"Typical bandwidth requirements", page
 VPN tunnel - A VPN tunnel needs to be established between the transmitter and
receiver. For more information,
Low network latency - Latency is the measure of time it takes for a data packet to travel

from one point to another. When configuring your WAN network, it would be best to
have as low a latency as possible.
Typical bandwidth requirements
The bandwidth required is typically as specified in the following table:
Resolution per stream
1920 x 1080 @ 60 Hz
1920 x 1200 @ 60 Hz
3840 x 2160 @ 30 Hz
3840 x 2160 @ 60 Hz
* Note: This is for a single video stream including audio and USB HID.
see "VPN configuration", page
Target bit rate (quality)
Low
Typical
Low
Typical
Low
Typical
Low
Typical
15.
Bandwidth per stream
*
(Mbps)
15
30
16.5
33.1
25
50
50
100
Matrox Extio 3 Series – User Guide 15
see
17.