Private Wan Configuration - Matrox Extio 3 Series User Manual

Private WAN configuration

To configure your Extio 3 extenders for operation over a private WAN:
Connect your devices –
1
Make sure the transmitter and receiver units are on the same VPN and you are connected
2
to the VPN.
Update your firmware to v3.01.50 or higher –
3
page
4 In the Extio Central Manager software, do the following:
16 Matrox Extio 3 Series – User Guide
see "Connecting your Extio 3 devices", page
44.
 Manually discover the receivers (
).
addresses
If the receivers and transmitters are on different subnets, make sure to configure the

receiver units to scan the transmitter subnets (
).
discovery
Assign user(s) to the devices using

 Allow the receiver and transmitter units to connect to one another using
.
broker
 Set to exclude guests (
Sharing mode

Sharing mode Guest connections
 Set
Encoding quality
).
Streaming
Set a value for

Network congestion control
The values are ,
Off Low
 Set the
Routing scheme
This only needs to be done if your setup does not support Multicast packets (for
example, GRE tunnels).
Set

Power recovery policy
This will allow the remote units to power up and return to a usable state.
see "Updating your Extio 3 firmware",
Manual device discovery
Manage users
Transmitter

No guest allowed
to if you require lower bit rate (
Low
(
, , and ,
Mid High
to (
Unicast Transmitter
to (
Always start Transmitter
28.

Scan a list of IP
 
Receiver Settings
.
 
Settings Connection
).
Transmitter

Transmitter Settings
 
Settings Streaming
 
Settings
Transmitter
Connection

 
Settings
).

Streaming
). Note:
).
More options