Changing the operation mode of your
devices
If you change the operation mode of your Extio 3 configuration (for example, changing from
networked mode to point-to-point mode, or vice versa, or from networked mode to virtual private
network mode), or vice versa, you need to do the following:
Disconnect the network cables from your Matrox transmitter device and receiver device
1
(see "Connecting your Extio 3
Perform a configuration reset on your transmitter device and receiver device
2
"Hardware reboot or configuration reset", page
Change the connection setup of your devices
3
page
4
Reboot both your Matrox transmitter device and receiver devices
resetting your Extio 3 device", page
RJ45 connections.
Configure your Extio 3 devices again:
5
Changing from copper to fiber optic
When you have to switch from copper Ethernet to fiber optic cables, you need to do the following:
Disconnect the network cables from your Matrox transmitter device and receiver device
1
(see "Connecting your Extio 3
Perform a configuration reset on your transmitter device and receiver device
2
"Hardware reboot or configuration reset", page
Switch the power off. Note: Never hot plug the SFP module.
3
4
Replace the copper cables with fiber optic cables.
Switch the power on.
5
28).
Networked mode – Use Extio Central Manager software to configure your devices.
For more information, see your Matrox Extio Central Manager user guide.
Point-to-Point mode – Use the OSD to configure your devices
point-to-point mode", page
devices").
77).
(see "Connecting your Extio 3 devices",
76). Note: This step is not required if you're using
70).
devices").
77).
Matrox Extio 3 Series – User Guide 79
(see
(see "Rebooting or
(see "Setting up
(see