Setting Up Point-To-Point Mode; Before You Begin - Matrox Extio 3 Series User Manual

Setting up point-to-point mode

Matrox Extio 3 transmitters and receivers can be configured as point-to-point extenders. In
point-to-point mode, Extio 3 transmitter and receiver devices are directly linked to each other using
copper or fiber optic cable.

Before you begin

 Whenever you change your connection setup, make sure you're using the correct
connectors and that all connectors are properly fastened. Also, don't change connections
while your Extio transmitter and receiver are turned on. For more information,
"Connecting your Extio 3 devices", page
 Make sure all of your Extio 3 transmitter and receiver devices are using the latest version
of the Matrox Extio 3 firmware package.
 To enable point-to-point mode, make sure your transmitter device and receiver device
are directly (physically) connected to each other. For more information,
your Extio 3 devices", page
 For information on supported cable types and distances,
(point-to-point mode)", page
 Review the safety information provided. For more information,
information", page
Software available in point-to-point mode
 On-Screen Display (OSD)
70 Matrox Extio 3 Series – User Guide
28.
28.
86.
6.
see
see "Connecting
see "Maximum distance
see "Matrox safety