Setting Up Networked Mode; Before You Begin - Matrox Extio 3 Series User Manual

Setting up networked mode

Your Matrox Extio 3 product is an IP KVM extender. In networked mode, Extio 3 devices operate over
a copper-based or fiber-based Gigabit Ethernet network.

Before you begin

 If you operate on a private Wide Area Network (WAN), make sure you have the required
bandwidth. For a private WAN to be supported, you should have Quality of Service
(QoS) and a Virtual Private Network (VPN) tunnel. For additional details, contact
Matrox.
Whenever you change your connection setup, make sure you're using the correct

connectors and that all connectors are properly fastened. Also, don't change connections
while your Extio transmitter and receiver are turned on. For more information,
"Connecting your Extio 3 devices", page
 Make sure your Extio Central Manager software is installed on a separate system on your
network, and you've set the allowed connections between your Extio transmitter and
receiver devices. For more information, see your Matrox Extio Central Manager User
Guide.
Make sure all of your Extio 3 transmitter and receiver devices are using the latest version

of the Matrox Extio 3 firmware package. For more information,
Matrox Extio 3 firmware (networked mode)", page
Make sure all your Extio 3 devices are using the same version of the firmware package.

Also, the version of your firmware package must match the version of your Extio Central
Manager software package.
To assign an initial IP address to your devices, a DHCP (Dynamic Host Configuration

Protocol) server is required.
Windows Server 2016 and Windows Server 2008 R2 – Make sure the SSDP Discovery

service, network discovery, and file sharing options are enabled.
28.
45.
Matrox Extio 3 Series – User Guide 49
see
see "Updating your