Hardware Reboot Or Configuration Reset - Matrox Extio 3 Series User Manual

OSD (point-to-point mode only)
From the OSD main interface, click
reboot your transmitter device or
your receiver device. You can also click
to reboot both the transmitter and the receiver devices.

Hardware reboot or configuration reset

WARNING:
resets all of your device settings, including the IP configuration and password.
WARNING:
also resets the settings of the transmitter device connected to the receiver.
Extio N3408 or N3208 transmitter card
Hardware reboot – Quickly press the button (1 second) to reboot your device.

 Configuration reset – Press and hold the button for 4-5 seconds (until the LED turns fast
blinking green) to reboot your device and restore the default settings.
Extio N3408 or N3208 unit
Hardware reboot – Press and hold the

paper clip for less than 2 seconds (until the LED turns slow blinking green) to reboot your
device.
Reboot transmitter
Reboot receiver
Reboot both devices
A configuration reset restores the default settings of your Extio 3 device. This
Point-to-point mode – Performing a configuration reset on an Extio receiver
to
to reboot
button on your device with the tip of a
Reset
Matrox Extio 3 Series – User Guide 77