Appendix B – Mounting your units
This section provides guidelines for mounting your Extio unit.
Mounting bracket
Your Extio unit can be mounted in a standard rack or under any hard surface (such as a desk).
The mounting holes on the unit are 4.25 inches (10.80 cm) apart. Use four 6-32 screws.
These screws can enter the casing by a maximum of 0.25 inches (6.35 mm).
WARNING:
your Matrox hardware.
Use a hand screwdriver to carefully tighten each screw. Make sure not to overtighten the
screws.
If installing your unit in a rack, fasten it to the rack as per your rack's instructions.
Mounting guidelines
To prevent damage to your Matrox hardware, read the following guidelines before mounting your
Matrox hardware:
Make sure not to block the ventilation holes on your unit.
Don't stack anything directly over the unit.
Make sure all cables and cords are slack.
Make sure the ambient temperature doesn't exceed the maximum recommended
temperatures. For more information,
Using screws that are longer or larger than those specified may damage
see "Environmental", page
50.
Matrox Extio Series – User Guide 55