Using The Osd (On-Screen Display) - Matrox Extio 3 Series User Manual

Enabling networked mode
Note:
from networked mode to point-to-point mode), you need to perform a configuration reset
of your devices. For more information,
page
To use
Networked
password (or if you've forgotten your user name or device password), contact your Extio 3
administrator.

Using the OSD (On-Screen Display)

If your devices are networked, the OSD enables you to log into your receiver and switch to different
transmitters.
Basic functions
Logout
Search
Configure aggregator mode
Wake-on-LAN
Rescan network
Disconnect
Connect
Get logs
Close
52 Matrox Extio 3 Series – User Guide
To change the operation mode of your Extio 3 configuration (for example, changing
79.
mode, you need a user name and password. To obtain a user name and device
Click this to log out of the device.
Search for a system by device serial number, friendly name,
IP address, or name of the user connected.
Use this to
and audio configuration. You can also
configuration. For more information,
page
Click this to wake up your transmitter if it turns off. This has
no effect if a transmitter isn't detected.
Click this to discover devices outside of the receiver's subnet
or unicast network.
Click this to disconnect from a transmitter.
Click this to connect to a new transmitter.
Click this to get detailed logs for troubleshooting.
Click this to close the OSD.
see "Changing the operation mode of your devices",
your aggregator mode layout, streams,
Configure
55.
and your
Edit Remove
see "Aggregator mode",