Matrox Extio 3 Series User Manual page 74

Enable advanced display
modes
Stabilize display output
Allow monitors to enter
power saving mode
Configure monitor behavior
on transmitter inputs
RS232 settings
To modify your RS232 settings, click
enable the
Enable RS232
Baud rate
Data bits
Parity
Stop bits
Flow control
When you're done, click
OSD access
Assign a keyboard shortcut for accessing the on-screen display (OSD).
74 Matrox Extio 3 Series – User Guide
Enable the
Enable advanced display modes
following display modes:

1× 3840×2160@60Hz + 1× 1920×1080@60Hz

1× 3840×1440@60Hz + 1× 1920×1080@60Hz

4× 2560×1600@60Hz

4× 1920×1200@60Hz
Enable this to reduce flickering associated with video output.
This option is enabled by default. For more information,
"Random display flickering occurs while using a point-to-
point connection", page
Enable this to turn off the display after X minutes of inactivity.
Select a
Monitor
output. If a monitor is currently connected, click
apply the EDID settings of that monitor. If using a 4K
resolution, make sure your transmitter reports only the
monitor (output) supported. In this case, your transmitter
must report the other monitors as disconnected (no monitor).
To report those monitors as disconnected, click
Edit RS232
option, edit your RS232 settings.
The speed, in bits per seconds (or baud), used for the RS232
connection. The default is 115200.
The number of bits per block of data transmitted. The default
is 8.
The type of parity bits (
transmitted. The default is
The number of bits used to identify the end of a data block.
The default is 1.
The signal type (
data transmission. The default is
.
Apply
81.
( , , , or ) to apply a fixed EDID to that
1 2 3 4
. This opens a new dialog box. To enable RS232,
, , or
None Odd
.
None
or ) used to pause and resume
None RTS/CTS
None
option to support the
see
to
Update
.
No monitor
) used for the data
Even
.