Changing The Operation Mode Of Your Devices - Matrox Extio N3408 User Manual

Changing the operation mode of your
devices
If you change the operation mode of your Extio 3 configuration (for example, changing from
networked mode to point-to-point mode, or vice versa), you need to do the following:
Disconnect the network cables from your Matrox transmitter device and receiver device
1
(see "Connecting your Extio 3
Perform a configuration reset on your transmitter device and receiver device
2
"Hardware reboot or configuration reset", page
3 Change the connection setup of your devices
page
Reboot both your Matrox transmitter device and receiver devices
4
resetting your Extio 3 device", page
Configure your Extio 3 devices again:
5
14).
Networked mode – use Extio Central Manager software to configure your devices.
For more information, see your Matrox Extio Central Manager user guide.
Point-to-Point mode – use the OSD to configure your devices
point-to-point mode", page
devices").
42).
(see "Connecting your Extio 3 devices",
41).
37).
Matrox Extio 3 Series – User Guide 43
(see
(see "Rebooting or
(see "Setting up