Hardware Reboot Or Configuration Reset - Matrox Extio N3408 User Manual

OSD (point-to-point mode only)
From the OSD main interface, click
reboot your transmitter device or
your receiver device.

Hardware reboot or configuration reset

WARNING:
resets all of your device settings, including the IP configuration and password.
Extio N3408 or N3208 transmitter card
Hardware reboot – Quickly press the button (1 second) to reboot your device.
Configuration reset – Press and hold the button for 4-5 seconds (until the LED turns fast
blinking green) to reboot your device and restore the default settings.
Rebooting your Extio N3408 or N3208 unit
Hardware reboot – Press and hold the
paper clip for less than 2 seconds (until the LED turns slow blinking green) to reboot your
device.
Configuration reset – Press and hold the
paper clip for 4-5 seconds (until the LED turns fast blinking green) to reboot your device
and restore the default settings.
42 Matrox Extio 3 Series – User Guide
Reboot transmitter
Reboot receiver
A configuration reset restores the default settings of your Extio 3 device. This
to
to reboot
button on your device with the tip of a
Reset
button on your device with the tip of a
Reset