Setting up point-to-point mode
Matrox Extio 3 transmitters and receivers can be configured as a point-to-point extender. In point-
to-point mode, Extio 3 transmitter and receiver devices are directly linked to each other using copper
or fiber optic cable.
Before you begin
Whenever you change your connection setup, make sure you're using the correct
connectors and that all connectors are properly fastened. Also, don't change connections
while your Extio transmitter and receiver are turned on. For more information,
"Connecting your Extio 3 devices", page
Make sure all of your Extio 3 transmitter and receiver devices are using the latest version
of the Matrox Extio 3 firmware package.
To enable point-to-point mode, make sure your transmitter deivce and receiver device
are directly (physically) connected to each other. For more information, For more
information,
For information on supported cable types and distances,
(point-to-point mode)", page
Review the safety information provided. For more information,
information", page
see "Connecting your Extio 3 devices", page
49.
5.
14.
14.
see "Maximum distance
Matrox Extio 3 Series – User Guide 37
see
see "Matrox safety