Table of Contents
Advertisement
5.3.3 FT50 PoE cable - M22/RJ45, USB
6CAPFT.0030-02 / 6CAPFT.0050-02
Notice!
In order to ensure sufficient contact between the pins on the connection, the cable must be secured
to the panel with a torque of at least 1.5 Nm.
It is important to note that this torque ensures the functionality of the USB connection and does not
ensure IP67 protection (for more information, see
1. Connect the Ethernet connector to the panel.
2. Tighten the cable gland (Torque: 3.0 Nm).
(See the figure in section
5.3.4 FT50 PoE cable - M22/M22
6CAPFT.0050-03
1. First connect one end of the cable to the injector.
Information:
For the procedure for installing an injector, see section
2. Connect the other end of the cable to the panel (see steps 1 to 2 in section
3. Tighten the cable gland (Torque: 3.0 Nm).
Power Panel FT50 User's manual V1.19
"FT50 PoE cable - M22/RJ45" on page
Installing different cable
32.)
"Mounting the injector" on page
FT50 PoE cable -
Installation
types).
31.
M22/RJ45).
33
Advertisement
Table of Contents
