Table of Contents
Advertisement
7.3.2.3 Boot logo
Filename: PPTLogo.bmp.gz
The boot logo is displayed during the startup phase of the Power Panel.
If configured on service page Startup, the boot logo is also displayed in web/VNC mode while establishing the
connection.
The boot logo must meet the following requirements:
File format
Only file format BMP (Windows bitmap) is permitted for the boot logo.
Size
The size of the graphic must correspond to the size of the display in full screen mode.
To determine the size of the display on the Power Panel being used, see section "Technical data".
Name
PPTLogo.bmp.gz
The boot logo must be compressed in GZ format (GNU ZIP file).
If the boot logo (any name possible) is added in Automation Studio and then the data for the USB
flash drive is generated, then Automation Studio will compress the boot logo into the GZ format and
name the file accordingly.
The user only has to make sure that the boot logo is compressed into the GZ format and the file is
named accordingly if Automation Studio is not being used.
Color depth
The color depth is limited to 24-bit.
7.3.2.4 Boot animation
Filename: PPTLogoA.gif
If configured on service page Startup, the boot animation is displayed in web or VNC mode while establishing the
connection.
The boot animation must meet the following requirements:
File format
Only file format GIF (Graphics Interchange Format) is permitted for the boot animation.
Size
The size of the boot animation is not permitted to exceed the size of the used display in full screen
mode.
Name
PPTLogoA.gif
If the boot animation (any name possible) is added in Automation Studio and then the data for the
USB flash drive is generated, then Automation Studio will name the file accordingly.
The user only has to make sure that the boot animation is named accordingly if Automation Studio
is not being used. It is important to ensure that capitalization matches the name specified above!
Position
When specifying the position of the boot animation (see service page
important to make sure that the entire boot animation can still be shown on the display.
Application
The boot animation is superimposed over an existing static boot logo.
The boot animation is only displayed when starting web or VNC mode. It is not displayed while the
device is booting.
The boot animation is only displayed when establishing the connection between the terminal and the
HMI application (web application). It is not displayed while the device is booting.
Power Panel FT50 User's manual V1.19
Configuration
"Screen" on page
62), it is
85
Advertisement
Table of Contents
