Table of Contents
Advertisement
5.2 Mounting the injector
Caution!
In order to ensure the following degrees of protection, the installation instructions and corresponding
notes must be strictly followed:
• IP67 protection (M22 connection)
• IP20 protection (housing)
5.2.1 Panel mount variant (6COPFT.0000-00)
1. Attach the round gasket to the injector (see
2. Guide the injector through the M22 hole.
3. Tighten the M22 nut (Torque: 10 Nm).
4. Secure the injector using the two screws (Torque: 1.3 Nm).
5. Connect the Ethernet connector:
6. Tighten the cable gland (Torque: 3.0 Nm).
Information:
For more information, see chapter
5.2.2 Top-hat rail installation (6COPOE.0000-00)
1. Guide the injector to the rail.
2. First allow the lower part for securing to the rail to snap into place.
3. Now press the injector against the rail.
Power Panel FT50 User's manual V1.19
"General information" on page
"Ethernet connection" on page
Installation
34).
49.
31
Advertisement
Table of Contents
