Table of Contents
Advertisement
Configuration
7.1.1.4 Service page Screen
On this service page, some settings for the display can be changed. The following graphic shows the default
settings:
Startup
Network
Time
Screen
Audio
Gesture
VNC
Web
Storage
Update
Backup & Reset
Display brightness
Default setting: 50
Input range: 0 to 100
Unit: %
Here, the current brightness of the display and the basic setting for the display are set after restarting the device:
• Each change to a value on the service page directly and immediately affects the brightness of the display.
• The currently set value is only stored as the default setting for the device when saved (see
Save & Exit" on page
Setting 0% on the service page corresponds to a residual brightness of 20%:
0%
10%
The brightness can also be controlled by the application (see
Screensaver
Default setting: Disabled
Options for the enabled screensaver are described in section
Screen rotation
Default setting: 0°
Input range: 0°, 90°, 180°, 270° (in 90° steps)
The angle of rotation of the display is set here. This setting affects how screen content is output. After selection,
the display content is rotated clockwise according to the specified angle.
62
Display brightness
0 to 100%
Screensaver
Screen rotation
Specify the screen rotation angle
Boot animation left pos
Animation offset from left side in pixels
Boot animation top pos
Animation offset from top in pixels
Boot animation delay
Boot animation delay in ms
79).
Brightness range of the display
20%
30%
40%
Range from 0 to 50
0
10
20
30
Setting range on the service page screen
50%
60%
70%
Range from 50 to 100
40
50
60
"Adjusting display brightness" on page
"Screensaver settings" on page
50
0°
0
0
0
"Service page
80%
90%
100%
70
80
90
100
86).
63.
Power Panel FT50 User's manual V1.19
Advertisement
Table of Contents
