Main Board Jumper Settings - Vecow SPC-6000 User Manual

2.5 Main Board Jumper Settings

2.5.1 Top View of SPC-6000 Main Board With Jumper Location
The figure below is the top view of the SPC-6000 main board. It shows the
location of the jumpers
JP2
JP3
JP1
You may configure your card to match the needs of your application by setting
jumpers. A jumper is a metal bridge used to close an electric circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To "close" a jumper, you connect the pins
with the clip. To "open" a jumper, you remove the clip. Sometimes a jumper will
have three pins, labeled 1, 2, and 3. In this case you would connect either pins
1 and 2, or 2 and 3.
2 3
1
Open Closed Closed 2-3
©Vecow SPC-6000 User Manual GETTING TO KNOW YOUR SPC-6000 28