Main Board Jumper Settings - Vecow VCM-1000 User Manual

2.4 Main Board Jumper Settings

2.4.1 Board top view of the system main board with jumper and DIP switch
1
JUSB2
1
4
1 1
4 4
M2E_MH1
JPOE_PWR1
JPOE_PWR1
IO_MH3
The figure below is the top view of the system main board which is the main
board. It shows the location of the jumpers and the switches.
You may configure your card to match the needs of your application by setting
jumpers. A jumper is a metal bridge used to close an electric circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To "close" a jumper, you connect the pins
with the clip. To "open" a jumper, you remove the clip. Sometimes a jumper will
have three pins, labeled 1, 2 and 3. In this case you would connect either pins 1
and 2, or 2 and 3.
You may configure your card to match the needs of your application by DIP
switch. As below show the DIP switch on and off.
©Vecow VCM-1000 User Manual
1 M2M_MH1
10
SYS_FAN1
JUSBPWR1
JUSBPWR1
ON
HWIGN_SW1
JIGNMODE1
JIGNMODE1
3 1
JIGN_FW1
2
4
6 4
I/O GND
VPP
M2B_SIM1
VCC
3 CLK 1
1
COM12_SW1
JUSB1
M2B
ON
M2B_CN1
COM12_SW1 JDEBUG1
74
M
67 57
75
119
IO_MH1
120
Open
ON
1 : OFF
2 : OFF
1 2
2
1
2
B2B_IO_CN1
M2B_LED1 M2E_LED1
2 3
1
Closed Closed 2-3
ON
1 : ON
2 : OFF
1 2
GETTING TO KNOW YOUR VCM-1000
IO_MH2
RST_SW1
1
3
HDD_LED1 PWR_LED1
2
4
ON
1 : ON
2 : ON
1 2
JHDA_SDO1
3
JCMOS1
8 7 1 2
BAT1 1
2 1
JCMOS1
IO_MH4
38