Main Board Jumper And Dip Switch Settings - Vecow EVS-1000 User Manual

2.5 Main Board Jumper and DIP Switch Settings

2.5.1 Board Top View of EVS-1000/1100 Main Board With Jumper and
DIP Switch
The figure below is the top view of EVS-1000/1100 main board which is the
main board. It shows the location of the jumpers and the switches.
JP6 JP7
SATA3
SATA4
JP5
CN12
JP8 JP9
MPCIE2
BZ1
MPCIE3
JP10
You may configure your card to match the needs of your application by setting
jumpers. A jumper is a metal bridge used to close an electric circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To "close" a jumper, you connect the pins
with the clip. To "open" a jumper, you remove the clip. Sometimes a jumper will
have three pins, labeled 1, 2 and 3. In this case you would connect either pins 1
and 2, or 2 and 3.
CN21
SATA1 J2
SATA2 J3
CN13
JP11
BAT1
JP2
MPCIE1
Closed
SODIMM_2
SODIMM_1
JP4
BIOS
CN17
J1
CN15 CN15
2 3
1
Closed 2-3
GETTING TO KNOW YOUR EVS-1000/1100
SYS_Fan1
CN18
SUMITB1
CN3
SUMITA1
SW2
35