Main Board Jumper Settings - Vecow MTC-1000 User Manual

2.4 Main Board Jumper Settings

2.4.1 Front View of MTC-1010W Main Board With Jumper Location
The figure below is the top view of the MTC-1010W main board. It shows the
location of the jumpers.
You may configure your card to match the needs of your application by setting
jumpers. A jumper is a metal bridge used to close an electric circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To "close" a jumper, you connect the pins
with the clip. To "open" a jumper, you remove the clip. Sometimes a jumper will
have three pins, labeled 1, 2, and 3. In this case you would connect either pins
1 and 2, or 2 and 3.
Open
©Vecow MTC-1000 User Manual
JP6
Closed
JP5
Closed 2-3
GETTING TO KNOW YOUR MTC-1000
JP3
JP2
JP7
JP4
2 3
1
15