Vecow SPC-6000 User Manual page 30

2.4.13 LAN1 : LAN Connector
There are two 8-pin RJ-45 jacks supporting 10/100/1000/2500 Mbps Ethernet connections
in the top side. LAN1 at low side is powered by Intel
upper side is powered by Intel
function is enabled. Using suitable RJ-45 cable, you can connect the system to a computer,
or to any other devices with Ethernet connection, for example, a hub or a switch. Moreover,
both of LANs support Wake on LAN and Pre-boot functions.
The pin-outs of LAN 1 and LAN 2 are listed as follows :
Pin No.
1
2
3
4
5
6
7
8
Each LAN port is supported by standard RJ-45 connector with LED indicators to
present Active/Link/Speed status of the connection. The LED indicator on the left side
lightens in solid green when the cable is properly connected to a 1000Mbps Ethernet
network; The LED indicator on the left side lightens in solid Yellow when the cable is
properly connected to a 2500Mbps Ethernet network; The left LED will keep twinkling/
off when Ethernet data packets are being transmitted/receive
Each LAN port is supported by standard RJ-45 connector
with LED indicators to present Active/Link/Speed status of the
connection.
LED Location LED Color 10/100Mbps 1000Mbps 2500Mbps
Left
Right
©Vecow SPC-6000 User Manual
®
i225-IT. When both of LANs work in normal status, iAMT
10/100MBps
E_TX+
E_TX-
E_RX+
--------
--------
E_RX-
--------
--------
Green/
Off
Yellow
Twinkling
Green
Green
®
i210-IT Ethernet engine; LAN2 at
1000/2500 Mbps
MDI0_P
MDI0_N
MDI1_P
MDI1_N
MDI2_P
MDI2_N
MDI3_P
MDI3_N
Solid Solid
Green Yellow
Twinkling Twinkling
Green Green
GETTING TO KNOW YOUR SPC-6000
LAN1
1 8
23