Main Board Jumper And Dip Switch Settings - Vecow IVH-9204MX ICY User Manual

2.5 Main Board Jumper and DIP Switch Settings

2.5.1 Board Top View of IVH-9200 Main Board With Jumper and DIP Switch
JP3
CN25
CN18 SATA2
SATA4
Mini PCIe 2
You may configure your card to match the needs of your application by setting
jumpers. A jumper is a metal bridge used to close an electric circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To "close" a jumper, you connect the pins
with the clip. To "open" a jumper, you remove the clip. Sometimes a jumper will
have three pins, labeled 1, 2 and 3. In this case you would connect either pins 1
and 2, or 2 and 3.
You may configure your card to match the needs of your application by DIP
switch. As below show the deep switch on and off.
©Vecow IVH-9204MX ICY User Manual
JP4
CN10
JP6
CN9
JP5
JP10
SODIMM2
J4
SATA1
FAN1
J2
SATA3
JP2
Mini PCIe 3
JP1
CN3
Mini PCIe 1
BIOS
JP9
Open
ON
1 : OFF
2 : OFF
1 2
J9 J8 J7
CN6
SODIMM1
Battery
J1
Closed Closed 2-3
ON
1 : ON
2 : OFF
1 2
GETTING TO KNOW YOUR IVH-9204MX ICY
J6
FAN2
SW2
M2_CN1
2 3
1
ON
1 : ON
2 : ON
1 2
CN15
39