Main Board Jumper Settings - Vecow EVS-2000 Series User Manual

2.5 Main Board Jumper Settings

2.5.1 Board Top View of EVS-2000 Main Board with Jumper and DIP Switch
The figure below is the top view of EVS-2000 main board which is the main
board. It shows the location of the jumpers and the switches.
JRI_PWR1
JRI_PWR2
You may configure your card to match the needs of your application by setting
jumpers. A jumper is a metal bridge used to close an electric circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To "close" a jumper, you connect the pins
with the clip. To "open" a jumper, you remove the clip. Sometimes a jumper will
have three pins, labeled 1, 2 and 3. In this case you would connect either pins 1
and 2, or 2 and 3.
JCMOS1
JP4
JIGNMODE1 SW2
JHDA_SDO1
Open Closed
JUSBPWR1
2
21
22
2 3
1
Closed 2-3
GETTING TO KNOW YOUR EVS-2000
1
43