Main Board Jumper Settings - Vecow RCX-1500 PEG User Manual

2.4 Main Board Jumper Settings

2.4.1 Board top view of the system main board with jumper and deep switch
The figure below is the top view of the system main board which is the main
board. It shows the location of the jumpers and the switches.
You may configure your card to match the needs of your application by setting
jumpers. A jumper is a metal bridge used to close an electric circuit. It consists of two
metal pins and a small metal clip (often protected by a plastic cover) that slides over
the pins to connect them. To "close" a jumper, you connect the pins with the clip.
To "open" a jumper, you remove the clip. Sometimes a jumper will have three pins,
labeled 1, 2 and 3. In this case you would connect either pins 1 and 2, or 2 and 3.
You may configure your card to match the needs of your application by DIP
switch. As below show the deep switch on and off.
©Vecow RCX-1500 PEG User Manual
JCMOS1
Open
ON
1 : OFF
2 : OFF
1 2
JCFG1
FAN2
JUSB_PWR1
Closed Closed 2-3
ON
1 : ON
2 : OFF
1 2
GETTING TO KNOW YOUR RCX-1500 PEG
COM2_RI
COM1_RI
SW1
2 3
1
ON
1 : ON
2 : ON
1 2
42