Main Board Jumper Settings - Vecow EAC-5000 User Manual

2.5 Main Board Jumper Settings

2.5.1.1 Board Top View of EAC-5000 Main Board with Jumper.
The figure below is the top view of EAC-5000 series main board which is the
main board. It shows the location of the jumpers.
JP3
JP8
JP2
JP1
SW6
JP4
JIGNMODE1
You may configure your card to match the needs of your application by setting
jumpers. A jumper is a metal bridge used to close an electric circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To "close" a jumper, you connect the pins
with the clip. To "open" a jumper, you remove the clip. Sometimes a jumper will
have three pins, labeled 1, 2 and 3. In this case you would connect either pins 1
and 2, or 2 and 3.
2 3
1
Open Closed Closed 2-3
You may configure your card to match the needs of your application by DIP
switch. As below show the DIP switch on and off.
©Vecow EAC-5000 User Manual GETTING TO KNOW YOUR EAC-5000/EAC-5100 35