Main Board Jumper & Deep Switch Settings - Vecow IVH-9200 User Manual

2.5 Main Board Jumper & Deep Switch Settings
2.5.1 Top View of IVH-9200 With Jumper and DIP Switch
JP3 JP4
CN25
JP6
JP5
CN18
SATA2 SATA1 J4
J2
SATA4 SATA3
Mini PCIe 2 JP2 Mini PCIe 3
JP1
Mini PCIe 1
JP9
The figure below is the top view of IVH-9200 main board which is the main
board. It shows the location of the jumpers and the switches.
You may configure your card to match the needs of your application by setting
jumpers. A jumper is a metal bridge used to close an electric circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To "close" a jumper, you connect the pins
with the clip. To "open" a jumper, you remove the clip. Sometimes a jumper will
have three pins, labeled 1, 2 and 3. In this case you would connect either pins 1
and 2, or 2 and 3.
CN10 J9 J8
CN9
JP10
FAN1
SODIMM 2 SODIMM 1
CN3
BIOS
Battery
J7 J6
CN6
SW2
J1
GETTING TO KNOW YOUR IVH-9200
CN15
FAN2
M2_CN1
35