Main Board Jumper & Deep Switch Settings - Vecow MTC-6000 User Manual

2.5 Main Board Jumper & Deep Switch Settings
2.5.1 Top View of MTC-6000 With Jumper and Deep Switch
CN11
J3
CN14
The figure below is the top view of MTC-6000 board, and it shows the location
of the jumpers and the switches.
You may configure your card to match the needs of your application by setting
jumpers. A jumper is a metal bridge used to close an electric circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To "close" a jumper, please connect the
pins with the clip. To "open" a jumper, please remove the clip. Sometimes a
jumper will have three pins, labeled 1, 2, and 3. In this case you would connect
either pins 1 and 2, or 2 and 3.
You may configure your card to match the needs of your application by DIP
switch as shown below (the deep switch on and off)
©Vecow MTC-6000 User Manual
JP6
J2
U19
CN30
Open
ON
1 : OFF
2 : OFF
1 2
CN31
CN33
JP2
JP4
CN32
SW1
CN12 CN13
J4 CN16
CN15
JP9
J5
J6
JP10
J7
Closed Closed 2-3
ON
1 : ON
2 : OFF
1 2
GETTING TO KNOW YOUR MTC-6000
JCOM3
JP3 JCOM4
JDIO1
CN10
JDIO2 JP5
J1
JP7
JP8
JP14 JP11
JP12
J8
2 3
1
ON
1 : ON
2 : ON
1 2
Battery
JP13
57