Calibration; Errors - Felix printers Pro L Quick Start Manual

Table of Contents

12 Z calibration

The z calibration involves probing both heads so the machine knows what level both extruders are at, this is crucial to avoid collision

and make a successful dual or multi material print.

To start the process see the instructions below.

After this the machine will heat up and begin probing the heads and comparing the results.

Normally the machine's Z offset is calibrated after this point but sometimes, a small change between them can be observed. This is

usually caused by having 2 probes which probe at different strengths which leads to them not being calibrated correctly, this is

easily adjusted see the instructions. This can only be done in the touchscreen or when connected to the machine by USB/web.

Page 27

Quick Start Guide FELIX Pro L / XL

Table of Contents

Pro xl