Felix printers Pro L Quick Start Manual page 33

1
1. Pull off edge connector of corresponding print head, do NOT pull the wires, there is also a small hook on the fan duct to which
the cable is fixed take it off this hook first.
2. Open the cover in front.
3. Rotate slightly to right
4. and Then pull out print-head
5. Reverse the assembly of the hot-end into the extruder assembly. Do not forget to close the lid.
IMPORTANT: Ensure the hot-end wires make the bend as shown in picture above
6. Please do the following two extruder calibrations, if you wish to properly print with dual head.
Z-height calibration
-
XY calibration
-
TIP: Clean hot-end exterior from filament before starting a print, to prevent blobs of plastic on your printed object.
Quick Start Guide FELIX Pro L / XL
3
4
2
Page 32