Dust Cleaners; Motion System - Felix printers Pro L Quick Start Manual

Table of Contents

15.2 Dust cleaners

Filament attracts a lot of dust and small particles. Make sure the filament enters the filament holder through the dust cleaner. After

a few months of printing it is recommended to replace the dust cleaners. Note remove the dust cleaners when using abrasive

filaments like carbon fiber filled or wood filaments.

The linear bearings require almost no maintenance. Recommended is that you put a little oil on them every 3-4 months.

The belt tension of the x and y axis can also be checked in intervals of 3 months.

In case of placing a new hot-end do the following two extruder calibrations, if you wish to properly print dual head.

Z-height calibration

XY calibration

Caution: There is a potential risk of burning, as the nozzle can reach temperatures of up to 275°

TIP: Clean hot-end exterior from filament before starting a print, to prevent blobs of plastic on your printed object.

Check the maintenance manual for more info.

Quick Start Guide FELIX Pro L / XL

Page 33

Table of Contents

Pro xl