13.1 Bigger nozzles
For bigger nozzles than the standard 0.5 nozzles you can still do the XY calibration but it's important to increase the flow rate under
the status menu, see how to below.
For 0.7 nozzles set the flow rate to 120%
14 Tips and tricks
14.1 Flexible Filaments
Our 3d printers can in general handle flexible filaments well. Depending on the amount of flexibility, you might need to take some
extra precautions to print it without trouble
.
Precautions
1.
Ensure you use the correct slicing profiles for flexible filaments from our supported software.
2.
Ensure the extruders are cleared from non-flexible filaments. It is essential that the filament does not experience any
obstructions in the hot-end barrel, before reaching the hot parts of the hot-end. Otherwise chances of buckling filament inside
the extruder are very high. Obstructions can occur if there has been printed with some hard filament before, make sure it is
removed from the barrel of the hot-end. This can be done by extruding some hard filament and then fully retract it again. Easy
way is to do it via the display unit. Then slowly extrude the fila flex into the hot-end.
Quick Start Guide FELIX Pro L / XL
.
Page 30