By adjusting the coating thickness you can bring the nozzle closer or further away from the bed, " – " brings it closer and " + "moves
farther.
Examples
Too far away, set it closer. You can see
the loose lines.
11.3 Errors during leveling
The machine uses the probe in the extruder to measure the build plate and adjust it accordingly to make the bed itself leveled,
during this process the probes are monitored and if they trigger you can get an error report that says bed leveling failed or g33
leveling failed. If this happens first check if the machine can home normally if the machine refuses to go up check our Z-sensor
triggered manual and bed calibration manual
Quick Start Guide FELIX Pro L / XL
Just a little too close. You can see it
start to build up at the edges.
Perfect first layer.
Page 26