Clean The Print Surface - Felix printers Pro L Quick Start Manual

Hide thumbs Also See for Pro L:

Table of Contents

8.3 Clean the print surface

Take out the print surface

The first layer is the most important layer of a print.

adhesion, take the following steps:

First remove any filament residue from the printbed surface, with a spatula or carefully with the tweezers.

Second use one of the two approaches to further prepare the surface:

Use the already applied Kapton layer on the flex plate and clean it with detergent like methylated spirit

or 100% alcohol . It must be absolutely grease free. Grease from fingers can ruin adhesion to the bed.

Use an adhesive like Magigoo, Pritt Powerstick, 3DLac or similar (Especially recommended for

larger prints).

Note: When using a spray adhesives ensure the flex plate is removed from the printer. The spray can

damage the linear motion components of the machine.

Quick Start Guide FELIX Pro L / XL

It forms the basis for the rest of the print. To ensure the proper first layer

Page 12

Table of Contents

Pro xl