8 Preparation for printing
8.1 The Basics
Below is the workflow described of 3D printing. With some pointers to ensure a successful print. This manual only covers the last
step in the process.
1.
Design
Follow the construction rules
✓
of 3D printing.
-
Limit overhang angles
-
See software quick start
manuals for more
information.
First Layer
Never leave printer unattended if you are not sure if first layer is printed correctly
8.2 Print bed Calibration.
IMPORTANT: Only PERFORM BED LEVELING after unboxing. The printer is already fully factory calibrated.
Quick Start Guide FELIX Pro L / XL
2. Slice
Choose correct settings
✓
according to type of print
object and chosen material
type.
Use up to date software
✓
Up to date slicing settings
✓
Followed slicing
✓
recommendations
3. Print
Filament guided to extruder
✓
with filament roll holder and
guiding tubes.
Filament not entangled on roll.
✓
Use good quality filament
✓
Ensure print surface is
✓
absolutely free from grease.
Ensure nozzles of print-head are
✓
clean.
Page 10